The Simplified Building Energy Model (SBEM) is the default method and software for assessing both target and proposed levels of CO2 emissions for non-residential buildings.
It was developed for the Department of Communities and Local Government (DCLG) by the Building Research Establishment (BRE). It provides analysis of the energy consumption of all buildings (other than dwellings), used in support of the National Calculation Methodology (NCM) and the Energy Performance of Buildings Directive (EPBD). SBEM is also used in determining CO2 emission rates for new buildings for compliance with Part L2A of the Building Regulations (England and Wales) and equivalent Regulations in Scotland and N Ireland.
The SBEM software:
Provides an analysis of a building’s energy consumption
Calculates energy use and CO2 emissions based on a description of the building’s geometry, construction, use, HVAC and lighting equipment
Assists the design process enabling specific advice to be given to enable compliance with the relevant Building Regulations to be achieved
Identifies and recommends improvements to the design with the minimum of complications and cost
The Assessment Process
The National Calculation Methodology (NCM), the procedure for demonstrating compliance with Building Regulations for buildings other than dwellings is used to calculate the projected annual energy use for a proposed building and compare it with the energy use of a comparable “notional” building. Both calculations make use of standard sets of data for different activity areas and call on common databases of construction and service elements.
A similar process is used to produce an “asset rating” in accordance with the EPBD. The NCM therefore comprises the underlying method plus the standard data sets. It will produce a rating of 1 (worst) to 100 (zero emissions).
There are two stages to the assessment process:
At the ‘design’ stage – an assessment needs to be completed and submitted to the Building Control Body or Approved Inspector at the same time as the Building Control Application.
At the ‘as-built’ stage – when the build is completed, a pass certificate will need to be produced and presented to the Building Control Body and approved by the Inspector.
The information required to complete the assessment is similar to that of undertaking a SAP assessment. The calculations need to be performed by a suitably qualified ‘Competent Person’, as certified by BRE or other accredited body.
For further details and information on SBEM please contact us.